PLASTIC HOSES
eba pneumatic plastic hoses are used as control lines in control and measurement technology, in laboratory technology, in devices and container manufacturing. Low weight, dynamic strength and extensive resistance against acids, alkalis and salt solutions are characteristic properties of this material.
LD-PE- PneumatiC HOSES
- Low weight
- High dynamic strength
- Extensive
- PE hoses are
PA 12 PHL- PneumatiC TUBES
- Flexible, practical to lay
- High temperature resistance
- Highly suitable for compressed air brakes, hydraulics and for fuel lines
- PA 12 PHL tubes are recyclable under EC Directives
- Also available as PA 12 HL
PA-SFL- PneumatiC TUBES
- Good to excellent hot air and weather resistance
- High abrasion resistance
- Small bending radius
- No plasticisers (therefore no ageing and embrittlement)
- PA-SFL tubes are recyclable under EC Directives
PUR- PneumatiC HOSES
- Little deformation after long-term loads
- High tensile strength
- Very good low-temperature flexibility
- High abrasion resistance
- High resistance against aliphatic hydrocarbons and most lubricating oils
- PUR hoses are recyclable under EC Directives
PUR-L- PneumatiC HOSES
- Good hydrolysis resistance
- High low-temperature flexibility
- Resistance against microorganisms
- Good wear resistance
- High tensile strength
- Very good damping capacity
- PUR-L compressed air hoses are recyclable under EC directives
DUO-/TRIO-/ QUADRO PneumatiC HOSES
- Compressed air hoses are welded together into
- For later attachment, every hose group is separated to the required length at both ends
- Use exclusively in combination with
Send a printed catalogue?
Contact us here and you will receive your printed catalogue version by post.